Installing a Stained Glass Lamp above Pool Table

By: Andrey Sorokin

If you want to install a stained glass lamp above your pool table, you should choose a light that has at least four 100-watt light bulbs in it. Modern lamps provide sharp looks and different colors to fit any lifestyle. You should consider height of the ceiling and room capacity when choosing the right lamp. The lamp should provide an adequate amount of light over the entire pool table. Also, the bottom of the light should hang down between 30 and 35 inches from the top of the table. Be aware that this type of lamp is usually heavy because of the thick glass and metal that frames it. You don't want a stained glass lamp to fall down from the ceiling, do you? To avoid this possibility, you'll need to secure the lamp in a special way, as opposed to a light weight lamp.

To start with, you'll need to remove any existing light before you proceed. If the light you're installing is a swag stained glass lamp that hangs from a chain on the ceiling, then you'll only have to install a metal hook for the lamp to hang on.

To do this securely, you'll need to use a stud finder to locate a stud in the ceiling. You need to locate a stud as close as you can to the spot where you want the stained glass lamp to hang. Mark the found spot, and then use an electric drill to carefully bore a starter hole in the ceiling. Then, insert the metal hook and turn the threads into the ceiling as far as it will go. Finally, hang the swag stained glass lamp up on the hook, and run the decorative chain and wire up and out of the way.

On the other hand, if the stained glass lamp needs to be connected to an electrical box above it, then you'll need to install it to an existing one. If no box exists, you'll need to install one. It would be a good idea to check with your local codes and permits department before you begin. You'll need to be aware of what the specific laws are regarding the wiring. And, be sure that the electrical box you install has a stud in the middle of the fixture. Before you start this all, make sure you read and follow the manufacturer's instructions and pictures that came with the electrical box. Then, after you shut off the power to the room you're working in, you'll need to cut a hole in the ceiling for the box to go in. You'll need to run a wire, if there isn't already one, from your breaker or fuse box to the box.

Install the stained glass lamp onto the box by attaching the fixture to the electrical box. Use a hickey, which is a metal piece with a hole in the middle of it. The hickey fits over the stud and a nut is placed on it afterwards. It helps to secure the fixture to the electrical box which is secured to the ceiling. Finally, make sure you have everything connected properlyFree Articles, and then turn the electric back on.

Share this article :

Most Read
• Stained Glass Art, Craft and Pricing
• Pool Table Buying Guide, by Bob Shanty
• The Infrared Heat Lamp, by James Carden
Top Searches on Furniture
•  Led Home Light Bulbs•  Ceiling Fan Light Fixture