To create a Christmas wreath you will need a wreath ring, a florist wire which can be bought from your local florist and some plants.
Collect interesting plants around the local park, on the countryside, or even in your own garden. Gather some evergreens, ivy, green and silvery grey leaves, and conifers.
In addition look out for some holly or other undergrowth that bear berries or berry-like fruits. Berries add color and elegance to the wreath. Look for some dried seedpods like poppies, and pinecones. Spray on some silver and gold paint on your collected seedpods to add attention to the wreath. Should you decide to use spray paint on any of these pieces, do it a few days to give the paint some time to dry. When using spray paint, always remember to follow strictly the instructions on its use found at the back of the can.
Making the wreath
To put together pieces of shrubs to the wreath ring, you need to cut a piece of wire and bind it around the lower end of the shrubs, then twist the wire around the wreath ring with one more piece of wire. Go over the same process until you reach an inch or two down the stem.
At the first encircling of the wreath, the shrubs will fall off a little bit, but the more shrubs you put on, the more it will become steady. Keep working on a flat tabletop to put off further movements.
However there are specific rules that you should always remember.
Use the interior and external rings as split 'rounds', stuffing both rings makes a full lush wreath.
You will come across later on, that you can actually make rounds appear following a direction. This happens when all the stems lay on the same direction. Wreaths look finest if a round pattern follows the similar direction. However, the two rings on the wreath ring don't essentially have to go in the equivalent direction.
Put aside the 'feature' or fancier items lastly, so that they stand out on the topmost layer of the Christmas wreath where they can be easily spot on.
To add some pine cones, bind some wire at the base part of the cone seeds, and entwine the two wire stems together tightly. Push the wire into the wreath and entwine them as one at the back of the wreath. You could also add some Christmas baubles by wiring them on or use other ornaments to add more glamour and beauty to you Christmas wreath.
When your Christmas wreath is finally finished, hang it on your front door for all the guests to see and appreciate. Remember, you need not to spend a lot of money just to make a beautiful Christmas wreath. All it takes is some skills and imagination and you'll surely have pretty one hanging on your door or lying on top of your table.
