Some Tips You Should Know Before Installing Your Satellite Dish

By: David Johnson

If you are thinking that you have to do any of theinstallation, or provide any of the hardware that is required for theinstallation job when you sign up for satellite TV service from either DirecTVor Dish Network you are mistaken, because they do all of the installation in upto four rooms in your home or business, as well as provide you with thesatellite system free of charge when you sign an extended service agreementwith either one of them.

The satellite TV system that they give is yours to own butthe installation is a one time deal though, so if you move you are responsiblefor having the system removed and reinstalled at your new residence. They willdo that for you also, but it requires a nominal fee and considering all thework that is involved, it is a good deal. Climbing up on your roof is dangerousand if the roof is at all icy in the least bit don’t get up on it unless youare suicidal.

?You can wait out thewinter by mounting your dish on a tripod, or you can rethink your strategy andlet the installation pros at Dish Network or DirecTV do this dangerous job andavoid a trip to the hospital. Assuming that your roof is safe to get on, youcan then walk around your house with a compass and select a place that has anunobstructed view of the southern horizon that you can mount the dish on.

?Before you mount thedish climb up into your attic and see if you can run the cable to the placethat you are planning on mounting your dish. If it is accessible, then run yourcable and push it through a hole that you have drilled or pass it through anear by vent hole. Don’t chince on mounting brackets and screws because theyare relatively inexpensive and you want a good sturdy attachment.

?If you are mountingthe dish to the side of your dwelling make sure that you attach it where youcan run your screws into the main framing members for a solid attachment. Toplay it safe, you should make sure that there are no wires or pipes where youare running your screw, because they have an uncanny way of being in the wrongplace at the wrong time.

?Pre drill pilot holeswhere you are going to screw into the wood to make sure that it doesn’t splitand that it gives a good solid connection. After you are done you can thenconnect the cable to it by using a rubber booted exterior cable connector. Doyour final adjustments using your compass and if there is a problem with yoursignal when you are doneFind Article, it may be that one of the connectors is on the cableimproperly. Use cable clips to attach any loose hanging cable to solid surfacesand then run the rest of the cable inside the house.

Top Searches on
Technology
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 
 • 

» More on Technology