Some people, after a hard day of racing, but the car away for the next event. However, when investing in few minutes before leaving the track to your long way to adding life to your RC car kit. It is definitely not as tedious as breaking down your RC car kits once a year to give it an overall. It is also definitely not as expensive as replacing parts, and perhaps the entire RC car kits, if you put off the regular daily maintenance.



The first thing you should do is to clean your radio controlled car kits. If you race in the mud, you will want to get it off before it crossed over inside every crevice of your night for car or truck. This not only affects the looks of the car but can also cause parts to break down more frequently than they would if you had not cleaned the car kit. Shake off as much dirt as you can, then spray some denatured alcohol to get the rest of it. If you are lucky enough to have an air compressor nearby, you can drive a car with it. Finally, spread the car with the silicone lubricant such as WD-40. Not only does WD - 40 displace water, you were also prevent corrosion and add a slippery surface to let the dirt slide off the next time.

The next thing you'll want to do is if you still have some gas left in the tank, you should drain it before putting the car way. Disconnect the feel one from the carburetor and. Feed it into your fear well. Plug in a fresh, clean feel too into the pressure fitting on the feel tank. Go into the tube but be careful not to inhale. This will help pump out any remaining fuel. Always drain the fuel into your bottle, never on the ground. Now, if you have raced into you ran out of gas, you don't have to blow the gas out of the tank, obviously. Instead, go ahead and start up the engine may idle and run into all the gases burned off the carburetor and the fuel line.

You should also lubricate the piston and sleeve. Take out the globe lad and use a light or else such as Hobbico After Run oil to drip into the engine. Turn the fly will gently to allow the world to circulate.