What is Alternator Noise?

Alternator noise is a high pitched whine caused by the car's electrical system. If the engine spins faster, noise frequency is higher. That is why you would hear alternator noise coming from mids and tweeters, but not subwoofers, since subwoofers only play low frequencies.

What causes this alternator noise?

1. Induced noise through RCA's:

When a wire has current through it, a magnetic field circles around it (i.e electromagnets). Conversely, if there is a magnetic field perpendicular to a wire, current will be induced. If you have your RCA wires from the radio or equalizer to the amp running in parallel to your power wires, an AC current will be induced and added to the sound signal. The sound signal travelling to the amp is a low voltage signal (in the mV range - thousands of a volt). The induced signal will be amplified along with the music.

To avoid this don’t run power and RCA wires together. If there are points in which they do have to cross, do the level best to place them perpendicular to each other. Run the power wire from the battery to the amp on one side of the car, and the RCA wires along the other side of the car.

2. Ground loops:

Your car's electrical system (and your stereo) use the car metal chassis as a ground (there is always current flowing through your car's metal parts). Theoretically the car's metal has no resistance, and it should not matter where you tie grounds for amplifiers, radio, battery and alternator. They all should "look" like the same point, right? Well, the metal in your car does have resistance, and there is a potential difference from the front of the car, where the battery is to the middle of the car, where the radio is, and to the back of the car, where most amplifiers are. The potential difference of the grounds makes the whole system act as an antenna, where they pick up noise. Measure voltages at the battery, amplifiers and radio. If there is a difference more than 1/2 volt, then you might have noise problems.

To correct this problem, make sure that the amplifiers have a good ground first. Use at least 10 Gauge wires for the grounds (and power). If you have 2 or more amplifiers, DO NOT go from the ground terminal of one amp to the other and then from there to ground, most likely you will have noise. Ground each amplifier independently.

Troubleshooting

If you installed everything using the above guidelines and you still have noise, then try to troubleshoot what is causing the noise . First, recheck grounds at amplifiers, crossovers, radio, etc. Make sure AM/FM antenna has a good ground. Try to figure out what is causing the noise.

If noise disappears, you know the problem is maybe RCA wires or grounds hooked up to crossovers/equalizers. If you have more that one amplifier and have noise only on one amplifier try switching RCA wires around. If noise stays the same, then problem is the amplifier, if it switches, noise is coming from previous components up the line. As said before, it is very difficult to find out what is causing alternator noise.

Don’t buy noise filter boxes unless you are certain that the head unit or equalizer are causing the noise. 99.9% of the time you will be wasting your money in buying noise filters.

If you have tried everything in the world, and still have that annoying noise, contact your nearest car stereo shop. Some stores may be hesitant to fix something they did not install. Look around for a good store.