Even if you keep your car in the pristine and clean, accidents happen. You can walk on the oil or grease that have infiltrated from other vehicles in May. And when you do, you can put your car in the car without your knowledge. Well, until you notice the stain of oil or grease on your carpet - or even on the tissues of your car.



One of the easiest ways to remove these stains or oil of your car in the interior is replacing oil or greased-up-up parts with new parts for Jaguar XJ6. But it could be very expensive on your end when you can simply remove the stain you simply using a little muscle work and a little sweat.

If you have grease or oil in the tissues of your car, you need to blot away any excess oil or grease, especially if these is still fresh on the tissues. After the blotting, and there are even more, you can try scraping them away. On the same place, put a fabric that is very absorbent and leave it there. Allow the fabric to absorb more oil or grease. Come back after a few hours, and this time, apply a laundry stain remover in the region. This would remove the stain.

Remember that should be done only in the tissues. If you get oil or grease on your leather seats or leather of your cabin, do not try to clean it or you could ruin it more? It is recommended to bring to professional leather cleaner instead.

It is better to work on one section at a time. It is also important to contain the flow of dirty water once you start using chemicals for cleaning. Many times you will be surprised by how high pressure cleaner degreaser without or with light degreasing. To make this easy to work correctly follow this guide step by step. First, check the water flow to ensure that dirty water cannot enter the gutter and then set the plastic cleaning and the use of two ovens to be placed in the outer edges of plastic stop the flow of water. Rinse the area clean before you start spraying then close and stubborn stains and paint chips and rinsing and see how it is good.

If it looks great, if you have not finished continue to the next round of measures. Spray degreaser on the areas to remove grease and oil hardened. Allow about 30 seconds of time to linger to soak in the blast at close range, with 15 degree tip and zero tip if necessary. Flush with the wide angle end and repeat until you are satisfied and continue this process on other sections.